Aldo Biagioli Tool Bar / Cultivators
ET-5 with tool carrier & drawbar
Constructed by Aldo Biagioli of Italy, these universal tools are available in 4 configurations and feature clamp-on shanks with standard reversible 1½” wide chisels. The working angle of the tool is controlled by the adjustment on the Tool Carrier (see below), and the overall penetration depth is controlled both by this angle adjustment AND the TWO removable/adjustable caster wheels that all of this brand of cultivators come with (other cultivators on the market have only a SINGLE depth wheel, which is problematic: With only one depth wheel, when one of the tractor wheels goes over a hump or into a depression, the shanks on one side of the cultivator lean to one side and “dig in” more, causing the tractor to veer in that direction).
Aldo Tool Bar with Shank-Mount Furrowers installed
The completely modular design of the Aldo Biagioli cultivators allow the clamps and shanks to be adjusted side-to-side or up-and-down on the frame. Shanks can also be removed, or, if you want to add more, shanks and clamps are available separately. Frame can be adjusted to free float (oscillate) or can be locked with plane of the tractor axle. Straight-bar styles (ET-3, 5 and 6) can have shank-mount Furrowers attached to the frame instead of shanks; and ALL styles accept Disk Hillers as well (see Double Ridger/Bedshaper tab above). Drawbar (shown below) attaches to tractor at PTO mounting, for a solid and sturdy mount. (Other brands of cultivators on the market attach at the tractor “tow hitch” mounting, which, in our testing, has proven to be a poor place to mount such an implement, as it is very hard to control the “side-swing” of the tool… the “limiter” bolts supplied on the tow-hitch type of tool carrier simply have very little surface to brace against, and they deform easily. We have chosen NOT to carry these other brands, due to this problem.)
FOR MOST EFFECTIVE USE, THIS IMPLEMENT MAY REQUIRE WHEEL WEIGHTS ON TRACTOR. 4 x 10 x 18” minimum wheel size recommended.
THIS TOOL REQUIRES THE DRAWBAR AND TOOL CARRIER SHOWN BELOW!! Angle of frame relative to tractor adjusted by T-handle crank on Tool Carrier…this allows “attack” angle of the tool to be adjusted. (NOTE: If purchasing multiple implements made by Aldo Biagioli, ONLY ONE Tool Carrier and Drawbar need to be purchased! Tool carrier and Drawbar change quickly from implement to implement with just one pin.)
Drawbar (Left) and AT-30-ET Tool Carrier (Right)
with hookup hardware